 This map of Ohio shows the wind resource at 50 meters.
The Department of Energy's Wind Program and the National Renewable Energy Laboratory (NREL) recently published a new wind resource map for the state of Ohio. This resource map shows wind speed estimates at 50 meters above the ground. Future plans are to provide wind speed estimates at 30 meters, which are useful for identifying small wind turbine opportunities.
As a renewable resource, wind is classified according to wind power classes, which are based on typical wind speeds. These classes range from class 1 (the lowest) to class 7 (the highest).
This map shows the highest wind resources in Ohio are found across the northwestern one-third of the state. Class 3 areas concentrated near Lake Erie with the largest contiguous area
extending from Sandusky towards Toledo. Other Class 3 areas are located northwest of Columbus on relatively high elevations. Particular locations in the Class 3 areas could have higher wind power class values at 80-m than shown on the 50-m map because of possible high wind shear. Given the advances in technology, a number of locations in the Class 3 areas may be suitable for utility-scale wind development.
The Ohio Department of Development, Office of Energy Effiency's Ohio Wind Resource Explorer Web site provides an interactive map and 30m, 70m, and 100m wind maps.
Note: Wind resource at a micro level can vary significantly; therefore, you should get a professional evaluation of your specific area of interest.
If you have a disability and need assistance reading the wind map, please email the Webmaster.
|
